CARBURETOR VACUUM SECONDARY DIAPHRAGM FOR HOLLEY 135-4 4150 4160 DEMON QUICK FUEL
iFJF part No.: FJ-CRRK14-KIT. Vacuum Secondary Diaphragm for Holley 4150/4160 135-4 Replacement Fix your Holley vacuum secondary carburetor with this direct replacement for the Holley 135-4 diaphragm assembly . When the secondary throttle plates won't open, you're leaving horsepower on the table this diaphragm restores proper vacuum-actuated secondary operation on Holley 4150, 4160, Demon, and Quick Fuel 4-barrel carbs . Key Features Exact 135-4 replacement Same dimensions, rod length (2.054"), and spring housing as Holley OEM Ethanol-resistant rubber Modern diaphragm material resists stiffening from E10/E15 fuels Pre-assembled Diaphragm, rod, and spring retainer in one unit Includes housing gasket Die-cut cork gasket for the diaphragm housing cover Compatible Carburetors Series Models CFM Range Holley 4150 0-3310, 0-4777, 0-4779, 0-80508 600-850 Holley 4160 0-1850, 0-80457, 0-80570 450-750 Demon Street/Speed/Mighty Demon (vac sec) 575-850 Quick Fuel HR, SS, Slayer (vac sec models) 580-850 Symptoms of a Failed Diaphragm Secondaries never open Engine feels like a 2-barrel; tops out early Slow or lazy secondary opening Diaphragm partially torn; delayed opening Secondaries flutter Diaphragm has a pinhole leak; vacuum signal inconsistent Rich condition at part throttle Diaphragm leaking fuel into vacuum chamber Quick Test Remove the vacuum hose from the secondary diaphragm housing. Apply vacuum with a hand pump. The secondary throttle shaft should move and hold position. If it doesn't hold vacuum, the diaphragm is torn. Frequently Asked Questions Q: How do I know if I need 135-4 vs 135-3? A: The 135-4 has a 2.054" rod length for universal Holley 4150/4160. The 135-3 has a shorter rod (Ford/Mopar OEM). Measure your existing rod. Q: Will this fit Quick Fuel SS-series carb? A: Yes. Quick Fuel vacuum secondary carbs use the same diaphragm assembly as Holley. Direct fit for HR, SS, and Slayer series. Q: Can I convert to mechanical secondary using this? A: This diaphragm is for vacuum secondary operation. To convert to mechanical, use this as a plug (block vacuum port) and install a mechanical secondary linkage kit (sold separately). Q: How long does installation take? A: 15-20 minutes. Remove the vacuum secondary housing cover (3 screws), swap the old diaphragm for new, replace the cork gasket. No carb removal required. Related Products Browse more in our collection . Search by part number
directions_car Aplicación (referencias cruzadas)
1| Marca | OEM | |
|---|---|---|
| UNKNOWN | FJCRRK14KIT | Ver ofertas |